7.7.5. Initiating a Software Upgrade
Utilities
Upgrade
yes
cancel
Note that the baud rate for firmware upgrades is 115200 baud.
In systems where the ARC series module is installed in a frame fitted with a 7700FC
VistaLINK
over Ethernet using the VistaLINK
7.7.6. Accessing Information About this Module and its Firmware
Utilities
About...
This control is used to initiate an upgrade of the module software.
In addition to the software upgrade method detailed in section 8.2, you
can initiate an upgrade with this control. This will allow you to upgrade
the software without unplugging the card and changing the upgrade
jumper.
After selecting the upgrade operation, you must change the command
to Yes and press the pushbutton before the upgrade can take place.
See the instructions in the Upgrading Firmware chapter for information
on how to connect the PC and upload the firmware. You can abort the
operation by pressing the pushbutton when Cancel is displayed.
After the upgrade has finished, the unit will automatically restart and
run in normal operating mode.
Frame Controller module, you can also upgrade the module firmware
®
This control lists the particulars about the module and the firmware
residing within it. It gives quick access information about revisions that
can be used to determine when upgrades are required.
Revision 1.1
7710ARC Series - SD Aspect Ratio Converter
Pro software.
®
7700 MultiFrame Manual
7710ARC-43