Recall Avc Configurations From The User Presets; Initiating A Software Upgrade; Restoring The Avc To Its Factory Default Configuration; Clear Faults And Peaks - evertz 7700 Manual

7700 MultiFrame Manual
7735AVC-LB Video Composite Encoder and Audio DAC with SoftSwitch

7.8.3.2. Recall AVC Configurations from the User Presets

Utilities
Recall preset 1
Recall,
Cancel

7.8.4. Initiating a Software Upgrade

Utilities
Upgrade
Yes
Cancel

7.8.5. Restoring the AVC to its Factory Default Configuration

Utilities
Factory reset
Yes
Cancel
7.9.

CLEAR FAULTS AND PEAKS

Clear faults and peaks
Clear,
Cancel
7735AVC-LB - 36
This control is used to initiate a recall of the current card configuration from
one of the user presets.
After selecting the recall preset operation, the user must change the
command to Recall and press the pushbutton before the store will take
place. The operation can be aborted by pressing the pushbutton when
Cancel is displayed.
Warning: There will be a slight disturbance in the operation of the card and
the on-screen display while the new preset is being recalled.
Warning: The current state of the card will be forgotten if it has not been
saved to a preset before a recall is performed.
This menu item is used to initiate an upgrade of the module software.
In addition to the software upgrade support detailed in this manual (See the
Upgrading Firmware section of this manual for more information), the user
can initiate an upgrade with this command. This will allow the user to
upgrade the software without unplugging the card and changing the
upgrade jumper.
After selecting the upgrade operation, the user must change the command
to Yes and press the pushbutton before the upgrade can take place. The
operation can be aborted by pressing the pushbutton when Cancel is
displayed.
After the upgrade has finished, the unit will automatically restart and run in
normal operating mode.
This menu item is used to restore all controls back to their factory defaults.
After selecting the reset operation, the user must change the command to
Yes and press the pushbutton before the command takes place. After the
command, all parameters will be set to their factory default. The operation
can be aborted by pressing the pushbutton when Cancel is displayed.
This menu item on the top level menu provides a convenient method to
clear any fault conditions and reset audio peak holds. The user can also
perform a clear by pressing the toggle switch up or down when not in the
menu structure or use a GPI if it is programmed to do so.
Revision 1.6