Vistalink ® Controlled Parameters - evertz 7710ARC Series Manual

9.3. VistaLINK CONTROLLED PARAMETERS
®
The following parameters can be remotely controlled through the VistaLINK
Parameter
Video Program Select
Video Standard Program
Video Loss of Program
Video Card Ref Source
Ext GL Source
Video Phase Offset Horizontal
Video Phase Offset Vertical
Ancillary Data Blanking
Active Picture Blanking Bypass
Gamma Enable
Gamma Level
RGB Clip
Y Gain
Y Offset
Cr Gain
Cr Offset
Cb Gain
Cb Offset
Hue
R Gain
G Gain
B Gain
Image Enhancement Enable
Detail Gain
Luma Floor
Detail Noise Floor
Enhancement Limit
Horizontal Band
Vertical Intensity
Fixed Arc
Input Image Aspect
7710ARC Series - SD Aspect Ratio Converter
Description
Selects the video input source (available on the 710ARC only)
Sets the input video standard.
Sets the behaviour of the program video output upon loss of the
program video input.
Sets the program video output reference source.
Sets the source of the external Genlock reference.
Sets the H phase of the program video output with respect to the
reference.
Sets the V phase of the program video output with respect to the
reference.
Sets if the ancillary data from the program video input is passed to the
program video output.
Sets the last line of the active picture that is to be treated as part of
the blanking region by the ancillary data bypass module. This allows
waveforms such as closed captioning to be passed to the program
video output.
This control enables the gamma adjust processor.
This control provides the ability to adjust the gamma correction factor
from -128 to +127 in steps of 1.
Enables the RGB clipper.
Provides the ability to adjust the gain of the Y component.
Provides the ability to adjust the DC offset of the Y component in the
Y Cr Cb domain in +/- 100 quantization levels.
Provides the ability to adjust the gain of the Cr component.
Provides the ability to adjust the DC offset of the Y component in the
Y Cr Cb domain in +/- 100 quantization levels.
Provides the ability to adjust the gain of the Cb component.
Provides the ability to adjust the DC offset of the Y component in the
Y Cr Cb domain in +/- 100 quantization levels.
Provides the ability to adjust the Hue or colour of components
+/- 30 degrees.
Provides the ability to adjust the gain of the R component.
Provides the ability to adjust the gain of the G component.
Provides the ability to adjust the gain of the B component.
Enables or disables Image Enhancement processor.
Provides the ability to adjust the amount of detail enhancement.
Selects the minimum Luma value that will be enhanced.
Provides the ability to set the detail noise floor.
Selects the largest detail value to be added back into the signal.
Selects the horizontal frequency band to be enhanced.
Selects the intensity of the vertical enhancement process, as a ratio
of the horizontal enhancement.
Configures the aspect ratio of the program video output using pre-
defined aspect ratios.
Selects the aspect ratio of the program input image. The parameter
allows the user to select standard aspect ratios, custom aspect ratios,
or aspect ratios specified by Active Format Description (AFD).
Revision 1.1
7700 MultiFrame Manual
interface.
®
7710ARC-47