7.5.
CONFIGURING THE VIDEO PROCESSING FUNCTIONS
The Video Proc menus are used to configure parameters associated with the video processing functions.
Table 7-8 shows the items available in the Video Proc menu. Sections 7.5.1 to 7.5.6 provide detailed
information about each of the menu items.
Gamma Adjust Enable
Gamma Level
RGB Clip
Enable/Disable
Y Gain
Y Offset
Cr Gain
Cr Offset
Cb Gain
Cb Offset
Hue
R Gain
G Gain
B Gain
7.5.1. Enabling Gamma Adjust
Video Proc
Gamma Enable/Disable
enable
disable
Enable/Disable Gamma Adjustment
Adjust Gamma correction
Enable/Disable Clipping the video to valid R, G, B values
Set the Y Gain of the output video
Set the Y Offset of the output video
Set the Cr Gain of the output video
Set the Cr Offset of the output video
Set the Cb Gain of the output video
Set the Cb Offset of the output video
Set the Hue of the output video
Set the R Gain of the output video
Set the G Gain of the output video
Set the B Gain of the output video
Table 7-8: Video Processing Functions
This control enables the gamma adjust processor.
When enabled, the module will allow the user to adjust the gamma
level (refer to section 7.5.2). If disabled, then the gamma level is set to
0.
Revision 1.1
7700 MultiFrame Manual
7710ARC Series - SD Aspect Ratio Converter
7710ARC-37