Table of Contents
Advertisement
LED 4:
This orange LED reports the status of the PGM IN BNC on the module. The LED will
be ON if the module does not detect a valid standard definition (525 or 625) SD-SDI
signal to be present.
LED 3 and LED 4 are similar, in that they both detect for valid signal presence.
However, LED 4 provides detection at the entry point only, where as LED 3
provides detection at a deeper processing level. These two LEDs are mutually
exclusive to one another. For normal operation with valid inputs, LED 3 should
remain ON and LED 4 should remain OFF.
LED 5:
Not used.
LED 6:
This green LED reports when the CPU is configuring the scaler.
LED 7:
Not used.
LED 8:
This green LED reports the status of the GENLOCK input signal (selected by the
External Genlock control – see section 7.3.5). The LED will be ON if the module
detects a valid Genlock signal to be present.
7710ARC Series - SD Aspect Ratio Converter
Revision 1.1
7700 MultiFrame Manual
7710ARC-9
Advertisement
Table of Contents
