Video Out; Firmware Upgrade Port; Table 2-1: Dvi-I Output Connector; Table 2-2: Com Port Pinout - evertz 2430GDAC-WARP Instruction Manual

2.3.

VIDEO OUT

DVI OUT: Output DVI-I connector for digital DVI video signals and analog RGB signals with
HSYNC and VSYNC. For analog output, use a DVI to DB-15 adapter to connect to
the computer monitor. Figure 2-1 lists the pins in the DVI-I Out connector.
Pin Signal
1 Data2-
2 Data2+
3 Data2/4 Shield
4 Data4-
5 Data4+
6 DDC Clock
7 DDC Data
8 Analog VSYNC
C1 Analog RED
C4 Analog HSYNC
2.4.

FIRMWARE UPGRADE PORT

COM: Serial port connector for upgrading the 2430GDAC-WARP firmware. This is a
female 9 pin D connector used for connecting to a standard computer serial port.
Table 2-2 shows the pinout of the female DB-9 connector. See section 5 for
information on upgrading the firmware in the 2430GDAC-WARP.
2430GDAC G-Link D to A Converter
Pin Signal
9 Data1-
10 Data1+
11 Data1/3 Shield
12 Data3-
13 Data3+
14 +5V Power
15 Ground
16 Hot Plug Detect
C2 Analog GREEN
C5 Ground

Table 2-1: DVI-I output connector

Pin # Name
1
2 TxD
3 RxD
4
5 Sig Gnd
6
7
8
9

Table 2-2: COM port pinout

Revision 1.2
Pin Signal
17 Data0-
18 Data0+
19 Data0/5 Shield
20 Data5-
21 Data5+
22 Data5/Clock Shield
23 Clock+
24 Clock-
C3 Analog BLUE
Description
RS-232 Transmit Output
RS-232 Receive Input
RS-232 Signal Ground
2430GDAC-3