Table of Contents
Advertisement
7700 MultiFrame Manual
7736CD2 Dual Composite Decoder
8.8.2.2. Recall Configurations from the User Presets
Utilities
Recall preset 1
Recall,
Cancel
8.8.3. Initiating a Software Upgrade
Utilities
Upgrade
Yes
Cancel
8.8.4. Restoring the Factory Default Configuration
Utilities
Factory reset
Yes
Cancel
Page - 28
This control is used to initiate a recall of the current card configuration from
one of the user presets
After selecting the recall preset operation, you must change the command
to Recall and press the pushbutton before the store will take place. You can
abort the operation by pressing the pushbutton when Cancel is displayed.
Warning: there will be a slight disturbance in the operation of the card and
the On-Screen display while the new preset is being recalled.
Warning: the current state of the card will be forgotten if it has not been
saved to a preset before a recall is performed.
This menu item is used to initiate an upgrade of the module software.
In addition to the software upgrade support detailed in this manual (See the
Upgrading Firmware section of this manual for more information), you can
initiate an upgrade with this command. This will allow you to upgrade the
software without unplugging the card and changing the upgrade jumper.
After selecting the upgrade operation, you must change the command to
Yes and press the pushbutton before the upgrade can take place. You can
abort the operation by pressing the pushbutton when Cancel is displayed.
After the upgrade has finished, the unit will automatically restart and run in
normal operating mode.
This menu item is used to restore all controls back to their factory defaults.
After selecting the reset operation, you must change the command to Yes
and press the pushbutton before the command takes place. After the
command, all parameters will be set to their factory default. You can abort
the operation by pressing the pushbutton when Cancel is displayed.
Revision 1.0.4
Advertisement
Table of Contents
