Table of Contents
Advertisement
5.2.2. Terminal Program Setup.
1. Connect the serial cable to the COM1 DB9 connector on the rear panel
2. Connect the 9 pin connector on the end of the serial update cable to the PCs' RS-232 communications
port
3. Start the terminal program.
4. Configure the port settings of the terminal program as follows:
5. Power up the HD9010-SIE unit.
5.2.3. Initiating Firmware Upgrade Mode Via The Front Panel
This is the recommended method of updating the software in the HD9010-SIE Source ID Encoder. It is
activated through the UTILITIES Setup menu. If you cannot invoke the upload mode via the front panel as
outlined in step 6 then follow the steps in section 5.2.4.
6. You can invoke the Firmware upgrade mode using the front panel Setup Menu. (See section 3.2 for
information on how to operate the front panel menus.) Press the UTIL key to enter the UTILITIES
Setup menu. Scroll to the FIRMWARE UPGRADE menu item by turning the SHAFT ENCODER knob
and then press SELECT. If you want to upgrade the main operating firmware in the HD9010-SIE then
turn the SHAFT ENCODER knob until the display shows yes and then press SELECT or press the
ESC key if you want to abort the programming operation.
When you press the SELECT key the unit will be placed in programming mode and its serial port is
opened to communicate with the terminal software program.
UPGRADING....
terminal program.
5.2.4. Initiating Firmware Upgrade Mode From The Terminal Program
You may send commands to the HD9010-SIE Boot monitor in order to upgrade the HD9010-SIE
application firmware.
7. Power up the HD9010-SIE. After the unit powers up, a banner with the boot code version information
should appear in the terminal window. The cursor to the right of the word "BOOT>" should be spinning.
For example:
TECHNICAL DESCRIPTION
HD9010-SIE High Definition Source ID Encoder Manual
Baud
Parity
Data bits
Stop bits
Flow Control
Proceed to section 5.2.5 for instructions on uploading the firmware using the
Rev 1
Rev 2
Hardware
Hardware
57600
115200
no
no
8
8
2
2
None
None
Revision 1.2
The front panel display shows
Page 5-3
Advertisement
Table of Contents
