evertz 7710ARC Series Manual page 54

7700 MultiFrame Manual
7710ARC Series - SD Aspect Ratio Converter
Input Image Custom Aspect
Input Video Aspect
Input Video Custom Aspect
Input Image Pan
Input Image Tilt
Input Image Crop
Conversion Type
Crop Pan
Crop Tilt
Output Image Aspect
Output Image Custom Aspect
Destination frame Aspect
Destination frame
Aspect
Output Image Pan
Output Image Tilt
Scaler Mode
Fill Source
Panel Colour Red
Panel Colour Green
Panel Colour Blue
AFD Out Enable
AFD Out Line
Pan Scan Out Enable
Pan Scan Out Line
Shoot Protect
Pan Scan Read Id
Pan Scan Write Id
Priority 1, 2, 3
WSS Enable
WSS read line
WSS write line
Input H Start
Input H Stop
Input V Start
7710ARC-48
Provides the ability to specify an image aspect ratio that is not
available in the Input Image Aspect control.
Selects the aspect ratio of the image in the program video input.
Provides the ability to specify a video aspect ratio that is not available
in the Input Video Aspect control.
Sets the pan (horizontal offset) of the image in the input program
video.
Sets the tilt (vertical offset) of the image in the input program video.
Provides the ability to set the number of pixels to be cropped off the
outer edges of the input image.
Selects the method used to "fit" the input image into the output image.
Sets the pan (horizontal offset) of the cropped image.
Sets the tilt (vertical offset) of the cropped image.
Selects the aspect ratio of the program video output image.
Provides the ability to specify an image aspect ratio that is not
available in the Output Image Aspect control.
Selects the aspect ratio of the destination frame.
Custom Provides the ability to specify a custom destination frame aspect ratio
Sets the pan (horizontal offset) of the image in the destination frame.
Sets the tilt (vertical offset) of the image in the destination frame.
Selects the behaviour of the Aspect Ratio Converter.
Selects what will be used to create the pixels outside of the output
image area.
Defines the R component for the colour of the panels.
Defines the G component for the colour of the panels.
Defines the B component for the colour of the panels.
Determines if AFD/Bar Data packets will be embedded into the
program video output.
Determines what line the AFD/Bar Data embedder will use.
Determines if Pan-Scan data is embedded into the program video
output.
Sets what line the Pan-Scan data embedder will use.
Determines if the shoot and protect area should be used to determine
the location of the image on the program video input.
Selects the Data Set ID to extract from the incoming Pan-Scan
packet.
Selects the Data Set ID used when embedding a Pan-Scan packet.
In the event that multiple AFD packets are received, the priority
controls are used to determine which packet to use. Priority 1 has the
highest priority.
Enables or disables the WSS processor
Selects which line to read the WSS data from
Selects which line to insert the WSS data on
The Input H Start defines the horizontal portion of the input image to
process to the output.
The Input H Stop defines the horizontal portion of the input image to
process to the output.
The Input V start defines the vertical portion of the input image to
process to the output.
Revision 1.1