Initiating A Software Upgrade; Accessing Information About This Module And Its Firmware; Jumpers; Figure 5: Location Of Jumpers - Rev D Main Module - evertz 7700 Manual

7700 MultiFrame Manual
7710UC-KF HD Key/Fill Up Converter

6.6.5. Initiating a Software Upgrade

Utilities
Upgrade
Cancel
Upgrade

6.6.6. Accessing Information About this Module and its Firmware

Utilities
About...
7.

JUMPERS

EVERTZ (C) 7710FT
MODULE STATUS
SIGNAL PRESENT
GENLOCK
Run
Upgrade
J7
FRAME
STATUS
ON
OFF
J5
7710UC-KF-20
This control is used to initiate an upgrade of the module software.
In addition to the software upgrade support detailed in the Upgrading Firmware
chapter in the front of the binder, you can initiate an upgrade with this control.
This will allow you to upgrade the software without unplugging the card and
changing the upgrade jumper.
After selecting the upgrade operation, you must change the command to
Upgrade and press the pushbutton before the upgrade can take place. Follow
the remainder of the instructions in the Upgrading Firmware chapter. You can
abort the operation by pressing the pushbutton when Cancel is displayed.
After the upgrade has finished, the unit will automatically restart and run in
normal operating mode.
This control lists the particulars about this module and the firmware residing
within it. It gives quick access to information about revisions that can be used
to determine when upgrades are required.
SFF POWER GND +12V
Figure 5: Location of Jumpers – Rev D Main Module
Revision 0.2
+5V +12V
J19
GPI LEVEL
75 HIZ
J21
REF TERM