7700 MultiFrame Manual
7714HDC High Quality Down Converter
6.10.5. Initiating a Software Upgrade
Utilities
Upgrade
Cancel
Upgrade
The Upgrade baud rate for the 7714HDC is 115,200 baud.
6.10.6. Accessing Information About this Module and its Firmware
Utilities
About...
7714HDC - 36
This control is used to initiate an upgrade of the module software.
In addition to the software upgrade support detailed in the Upgrading Firmware
chapter in the front of the binder, you can initiate an upgrade with this control.
This will allow you to upgrade the software without unplugging the card and
changing the upgrade jumper.
After selecting the upgrade operation, you must change the command to
Upgrade and press the pushbutton before the upgrade can take place. Follow
the remainder of the instructions in the Upgrading Firmware chapter. You can
abort the operation by pressing the pushbutton when Cancel is displayed.
After the upgrade has finished, the unit will automatically restart and run in
normal operating mode.
This control provides the basic module information and the firmware version of
the card. It gives quick access to information about revisions that can be used
to determine when upgrades are required.
Revision 1.1