7.6.
CONFIGURING IMAGE ENHANCEMENT
The Image Enhancement menus are used to configure parameters associated with the image
enhancement functions. Table 7-9 shows the items available in the Image Enhancement menu. Sections
7.6.1 to 7.6.7 provide detailed information about each of the menu items.
Image Enhancement
Enable
Detail Gain
Luma Floor
Detail Noise Floor
Enhancement Limit
Horizontal Band
Vertical Intensity
7.6.1. Enabling Image Enhancement
Image Enhancement
Image enhancement
enable
disable
7.6.2. Setting the Detail Gain
Image Enhancement
Detail Gain
20
0 to 127
7.6.3. Setting the Luma Floor
Image Enhancement
Luma Floor
1
0 to 15
7710ARC Series - SD Aspect Ratio Converter
Enable/Disable Image Enhancement
Set the Detail Gain for image enhancement
Select minimum Luma value
Select noise floor
Select the largest detail value to be added back into the signal
Select the horizontal frequency band to be enhanced
Select the intensity of the vertical enhancement process
Table 7-9: Image Enhancement Controls
This control enables or disables the Image Enhancement processor.
When enabled, the module will provide the ability to adjust the image
enhancement parameters. If disabled, the image enhancement
processor has no effect on the video.
This control provides the ability to adjust the amount of detail
enhancement.
This control can be adjusted in increments of 1 from 0 to 127.
This control selects the minimum Luma value that will be enhanced.
Pixels with a luma value below this floor will be left untouched.
Revision 1.1
7700 MultiFrame Manual
7710ARC-39