Selecting The Conversion Mode; Selecting The Source Of The Fill (7710Arc-F Version Only); Set The Colour Of The Letterbox Panels - evertz 7710ARC Series Manual

7700 MultiFrame Manual
7710ARC Series - SD Aspect Ratio Converter

7.4.5. Selecting The Conversion Mode

ARC Control
Scaler mode
aspect ratio
manual

7.4.6. Selecting The Source Of The Fill (7710ARC-F version only)

ARC Control
Fill source
panel
fill BNC

7.4.7. Set The Colour Of The Letterbox Panels

There are three menu items used to set the panel colour. The menu item for each colour component
functions in the same way. For simplicity, only the menu item for the Red component will be shown in the
manual.
ARC Control
Panel colour red
0 to 255
7710ARC-36
This control is used to select how the aspect ratio converter is
configured.
When set to aspect ratio the controls in the Aspect Ratio Scaler Mode
menu (refer to section 7.4.1) are used to configure the conversion
process.
When set to Manual, the controls in the Manual Scaler Mode menu
(refer to section 7.4.2) are used to configure the conversion process.
Select what will be used to create the pixels outside of the output image
area. This control is only available on the 7710ARC-F.
When set to panel, the module will insert a solid colour into the panel
area. The solid colour can be adjusted using the Panel colour controls,
refer to section 7.4.7.
When set to Fill BNC, the FILL input frame is placed over the entire
destination frame, before the output image is inserted. The Fill video
signal must be in the same video standard as the program video input
and must be clock locked to the program input.
This control defines one of the component colours for the colour of the
letterbox or pillarbox panels. Set the R, G or B value for the desired
panel colour.
Revision 1.1