Table of Contents
Advertisement
7700 MultiFrame Manual
7710UC-HD HD UpConverter
6.9.2. Saving Configurations to the User Presets
The 7710UC-HD modules provide ten user preset areas to store the complete set of controls from the on
screen menu.
Utilities
Store Preset
Cancel
1 to 10
6.9.3. Initiating a Software Upgrade
Utilities
Upgrade
Cancel
Upgrade
6.9.4. Enabling the Status Window
Utilities
Status Window
Disable
Enable
7710UC-HD-26
This control is used to initiate a store of the current card configuration into
one of the user presets
Use the toggle switch to select the preset location where you want to store
the module configuration. After selecting the preset, you must press the
pushbutton before the store will take place. You can abort the operation by
pressing the pushbutton when Cancel is displayed.
This control is used to initiate an upgrade of the module software.
In addition to the software upgrade support detailed in the Upgrading
Firmware chapter in the front of the binder, you can initiate an upgrade
with this control. This will allow you to upgrade the software without
unplugging the card and changing the upgrade jumper.
After selecting the upgrade operation, you must change the command
to Upgrade and press the pushbutton before the upgrade can take
place.
Follow the remainder of the instructions in the Upgrading
Firmware chapter. You can abort the operation by pressing the
pushbutton when Cancel is displayed.
After the upgrade has finished, the unit will automatically restart and
run in normal operating mode.
This control is used to enable or disable the on screen status window
When set to Enable the following status parameters will be enabled
Video Conversion
Video Delay
Genlock
Audio Group 1
Audio Group 2
Audio Group 3
Audio Group 4
Time Code
Closed Captions
Revision 1.3
Advertisement
Table of Contents
