Selects The Horizontal Phase Offset; Selects The Vertical Phase Offset; Select If Ancillary Data (Non-Video) Is Passed To The Output; Bypass Blanking Of Active Picture Before The Selected Line - evertz 7710ARC Series Manual

7.3.6. Selects The Horizontal Phase Offset

Video
H phase offset
0
0 to Max

7.3.7. Selects The Vertical Phase Offset

Video
V phase offset
0
0 to Max

7.3.8. Select If Ancillary Data (Non-Video) Is Passed To The Output

Video
Ancillary data
Pass
Blank

7.3.9. Bypass Blanking Of Active Picture Before The Selected Line

Video
AP Blanking Bypass Line
Line 0 to 5
7710ARC Series - SD Aspect Ratio Converter
This control is used to set the H phase of the program video output with
respect to the reference set by the Reference select and External
Genlock controls.
The range of this parameter is 0 to max samples, where max
represents the maximum number of horizontal samples per line for the
program video input standard.
This control is used to set the V phase of the program video output with
respect to the reference set by the Reference select and External
Genlock controls.
The range of this parameter is 0 to max lines, where max represents
the maximum number of vertical lines per frame for the program video
input standard.
This control determines if the ancillary data from the program video
input is passed to the program video output.
When set to pass, the module will take all the ancillary data (audio, time
code, VANC data etc.) and pass it to the program video output.
When set to blank, the module will not pass any of this data to the
program video output.
This control determines if any of the source frame lines are to be
treated as part of the blanking region and passed to the program video
output when the Ancillary Data control is set to pass.
waveforms such as closed captioning to be passed to the program
video output instead of being passed through the image conversion
process.
When set to 0, all the lines of the source frame (Line 20 for 525i/59.94
and line 23 for 625i/59.94 and beyond) will go through the scaling
process.
Otherwise, the top x (where x is the value of this control) source frame
lines will bypass the image conversion process and be passed directly
from the program video input to the program video output. If the scaler
input and output controls include these lines, they will be blanked prior
to sending them to the scaler.
Revision 1.1
7700 MultiFrame Manual
This allows
7710ARC-21