Vistalink; Parameters For Mfx-Hd In Decode Mode; Vistalink General Tab; Figure 9-6: General Tab In Decode Mode - evertz 7772MFX-HD Manual

7700 MultiFrame Manual
7772MFX-HD JPEG2000 SD & HD Encoder and Decoder
9.3.

VISTALINK

PARAMETERS FOR MFX-HD IN DECODE MODE

®
9.3.1. VistaLINK GENERAL TAB
®
Parameter
Vistalink Enable
FPGA 1 Revision
FPGA 2 Revision
FPGA 3 Revision
Firmware Revision
Card Type
Switch Image Control
7772MFX-HD - 42

Figure 9-6: General Tab in Decode Mode

Description
This field indicates whether the 7772MFX-HD is under local control or
VistaLINK control.
®
This field displays the revision code of the main board FPGA.
This field displays the revision code of the JPEG2000 sub-board FPGA.
This field displays the revision code of the audio sub-board FPGA.
This field displays the firmware version string.
This field identifies the Card Type parameter. Currently this field returns
either '7772MFX-HD in Encode' or '7772MFX-HD in Decode'.
To switch the card image between JPEG2000 encoder and decoder.
NOTE: When this control is set successfully, the card will reboot and load
the newly switched to image.
Table 9-6: VistaLINK
Revision 1.2
General Tab
®