Setting The C-Bit Control; Enabling The Audio Embedders; Setting Where To Output The Audio; Configuring The Transport Stream Control - evertz 7772MFX-HD Manual

7700 MultiFrame Manual
7772MFX-HD JPEG2000 SD & HD Encoder and Decoder

7.3.4. Setting the C-bit Control

Audio Control
CBIT
Preserve PRO
Replace STMP

7.3.5. Enabling the Audio Embedders

There are four menu items used to enable embedder groups. The menu item for each embedder group
component functions in the same way, therefore for simplicity only the menu item for Embedder Group 1
will be shown in the manual.
Audio Control
EMB1
Enable ON
Disable OFF

7.3.6. Setting where to Output the Audio

Audio Control
AOUT
Embedded
AES
Both
None
7.4.

CONFIGURING THE TRANSPORT STREAM CONTROL

The chart below shows the items available in the "transport stream control menu".
TSID Tune to Program
TSST Reset of TS Stats
7772MFX-HD - 26
This control determines how the AES channel status bits are handled
when being routed from input to output. When set to preserve, the
module will preserve as many bits as possible, but always change to
professional 48 kHz. When set to replace, all the C-bits will be replaced
with a static channel status message that reads professional 48 kHz.
This control enables or disables audio embedder for group 1.
When Enable is selected, Group 1 will be embedded into the output
video signal.
When Disable is selected, Group 1 will not be embedded into the output
video signal.
This control enables the user to choose the output audio of AES and
Embedded audio.
Selecting Both will output audio to both AES and embedded audio.
Selecting None will cut off audio from both AES and embedded audio.
Sets the program number.
Resets the statistics.
Revision 1.2