Table of Contents
Advertisement
5550 End
Parallel I/O
(Male 9 pin D)
Frame Gnd
BIPH 1
GND
BIPH 2
GND
TLC End
(Female 25 pin D)
GPO
Gnd
Gnd
6 Hz In
Figure 2-21: Cable to Connect Sony Vialta Biphase to the 9025TR
The telecine type item on the KeyLog TRACKER™ Telecine Setup screen must be set to Sony Vialta.
The film frame handling will be set to "Active High" Style when you set the Vialta Telecine type. If your
Telecine has an active low pulse then you will have to manually set the film frame handling to "Latch
Negative Transition" style.
2.14.3. Verifying the Connections to a Sony Telecine
When you have completed the basic telecine connections, you will need to verify the frame accuracy of
the basic system using the procedure in Chapter 3.
2.15. CONNECTING A FILM BARCODE READER
With the introduction of machine readable edge numbers by Eastman Kodak and other film stock
manufacturers, (referred to as KeyKode numbers), the edge number information can now be read by a bar
code reader. This eliminates the tedium and human error or manual entry, and provides an absolutely
accurate identification, entry and tracking of film edge numbers.
The 9025TR Film Footage Encoder interfaces to the Evertz Model 5550 Universal Film Data Decoder.
This KeyKode reader is a self contained unit and consists of a bar code pickup head, and a decoder
device. The pickup head transforms the optical dark and light bar code into electronic signals and is
designed specifically to mount on the telecine feed roller just before the film enters the gate. The decoder
receives these electronic signals from the pickup head, and sends the decoded KeyKode number via an
RS-232 serial link to the Film Footage Encoder, for automatic placement into the time code.
The 9025TR also interfaces to the older Evertz model 5500 and RIM DigiSync KeyKode Decoders. (See
section 2.15.2 for information about connecting these decoders).
INSTALLATION
--drain--
3
--Pair 1--
6
--Gnd 1--
7
--Pair 2--
6
--Gnd 2--
J16
2
--------
14
--------
13
6 Hz Ground
7
6 Hz Input from 7750SRG
9025TR Series Film Footage Encoders Manual
9025TR End
Parallel I/O
(Male 9 pin D)
Frame Gnd
--drain--
Film Rate
1
FRID/SOF
2
BIPH 1
3
--Pair 1--
GND
6
--Gnd 1--
Def
4
Load Film
5
BIPH 2
7
--Pair 2--
GND
6
--Gnd 2--
DLO GPI
8
GND
6
-----
9
Revision 1.3
Sony End
Aux 6
(Male 9 pin D)
Frame Gnd
Shld
tach10B-
6
Ground
4
tach10A-
9
Ground
4
Page 2-29
Advertisement
Table of Contents
