Table of Contents
Advertisement
4.
SYSTEM PARAMETERS AND DEBUG WINDOWS
4.1.
SYSTEM PARAMETERS
The 9025TR HD/SD Film Footage Encoder hardware allows the user to change the default behaviour of
various functions by the use of parameters. These parameters are grouped according to classes. Within
each class parameters are identified by a parameter number. Each parameter has a value with the default
value for each parameter being zero. Parameter classes 0 and 25 apply to the 9025TR and will be
described in this chapter. (Table 4-1 to Table 4-4 show the currently defined parameters for each class
with a brief description of what each parameter does.) The parameters in class 1 are specific to different
telecine types. Each Telecine Setup in the Tracker software stores a separate set of Class 1 parameters.
The parameter numbers shown in the tables below are decimal numbers. The following sections describe
the operation of each parameter in detail.
Parameter
0
Auto Video Standard Disable
2
Num-Print disable
Parameter
0
9025 VideoAdjust
1
9025 FilmAdjust
2
9025 AudioAdjust
10
9025 OffCenterTAdjust
11
9025 OffCenterEAdjust
12
9025 OffCenterAAdjust
18
9025 6HZPhaseAdjust
21
9025 Biphase Max X Play
22
9025 Biphase Reverse
23
9025 Biphase Average Size Adjust
Table 4-2: Class 1: Telecine Parameters (linked to a specific telecine type)
Parameter
0
9025 Parallel I/O Port Pin 1
1
9025 Parallel I/O Port Pin 8
2
9025 Parallel I/O Port Pin 4
3
9025 Parallel I/O Port Pin 9
4
9025 Parallel I/O Port Pin 5
20
9025 Deferred event end enable
27
9025 Legacy Ink frames Enable
30
9025 Character Horizontal Offset
31
9025 Character Vertical Offset
32
9025 KK port low baud enable
33
9025 KK Decoder Control Enable
34
9025 KK Decoder status polling disable
35
9025 Lock Exit Control
SYSTEM PARAMETERS
Name
Table 4-1: Class 0 - Global System Parameters
Name
Name
Table 4-3: Class 25 - 9025 System Parameters
Revision 1.3
9025TR Series Film Footage Encoders Manual
Description
Non-zero value disables auto video standard
Non-zero disables debug print of KK,TC numbers
Description
Trim for video timecode dynamic numbers
Trim for film dynamic numbers
Trim for audio timecode dynamic numbers
Biphase video time # offset at center point
Biphase edge # offset at centre point
Biphase audio time # offset at centre point
Adjust 6Hz cycle: frms of 24P input video w.r.t. 30Fps ref.
Biphase filter max, as a multiple of play speed
Non-Zero reverses Biphase direction
Adjusts size of average from default of 8
Description
Input/Output function for this pin (See section 2)
Input/Output function for this pin (See section 2)
Input/Output function for this pin (See section 2)
Input/Output function for this pin (See section 2)
Input/Output function for this pin (See section 2)
Non-zero enables special event end handling
Non-Zero to enable binary/legacy ink frame ANC numbers
Signed Horizontal pixel offset from default
Signed Vertical scan line offset from default
Non-zero enables 9600 baud KK interface
Non-Zero enables remote control of 5550 on KK port
Non-zero disables polling for 5550 status
Non-Zero disables grabbing Lock Exit 1 A Frame early
Page 4-1
Advertisement
Table of Contents
