Table of Contents
Advertisement
5550 End
Parallel I/O
(Male 9 pin D)
Frame Gnd
BIPH 1
GND
BIPH 2
GND
TLC End
(Female 25 pin D)
GPO
Gnd
Gnd
6 Hz In
Figure 2-12: Cable to Connect URSA Gold / URSA Diamond / RASCAL Biphase to 9025TR
Connect the Frame BNC (BSK 33) on the telecine to the FRAME PULSE IN connector on the 9025TR. If
necessary, you can use a BNC "T" connector and continue the coax to other devices.
Do not terminate this signal.
Connection of a Film frame pulse is required even with 1:1 video transfers in 1080I,
525i and 625i to permit the 9025TR to distinguish the difference between the field 1
and field 2 dominant pull downs.
URSA Gold telecines with firmware versions prior to 5.06 have different internal timing with respect to the
Film Frame pulse output. In order to compensate for these timing differences you need to select the
correct telecine type using the KeyLog TRACKER™ software. The film frame handling will be set to
DIRECT when you set one of the URSA Gold or URSA Diamond types.
2.11.4. Cintel C-Reality / DSX
The Biphase tach pulse is available on the 15 pin D Sep Mag connector on the rear of the telecine. These
biphase signals must be connected to pins 3 & 7 of the 9 pin parallel I/O D connector of the 9025TR and
the Parallel I/O connector on the KeyKode Decoder as shown in Figure 2-13. Retain the separate
shielding of each signal up to the 9025TR in order to prevent cross-coupling which can adversely affect
the biphase reliability.
INSTALLATION
--drain--
3
--Pair 1--
6
--Gnd 1--
7
--Pair 2--
6
--Gnd 2--
J16
2
--------
14
--------
13
6 Hz Ground
7
6 Hz Input from 7750SRG
9025TR Series Film Footage Encoders Manual
9025TR End
Parallel I/O
(Male 9 pin D)
Frame Gnd
Film Rate
1
FRID/SOF
2
BIPH 1
3
--Pair 1--
GND
6
--Gnd 1--
Def
4
Load Film
5
BIPH 2
7
--Pair 2--
GND
6
--Gnd 2--
DLO GPI
8
GND
6
-----
9
Revision 1.3
Cintel End
Sep Mag
BNC
PH0_B
Ground
PH1_B
Ground
Page 2-19
Advertisement
Table of Contents
