Table of Contents
Advertisement
HD PROGAM IN
Input BNC connector for 10-bit serial digital video signals, compatible with the
SMPTE 292M standard.
HD9025TR are capable of working with the high definition video formats shown in Table 2-4.
DDR IN HD
This input BNC connector (available only on the HDSD9025DDR) is for 10-bit serial digital
video signals, compatible with the SMPTE 292M standard. This input is used to recover VANC
data from the DDR source and should be connected directly to the video output of the Digital
Disk Recorder.
HD PROGAM OUT
High definition serial digital video output with the Ancillary data Film Descriptor
packet and optional characters inserted. There are two BNC connectors which output identical
program video in serial component format, compatible with the SMPTE 292M standard.
2.1.2. Standard Definition Video Connections
The SD9025TR and the HDSD9025TR operating in the standard definition mode use the following
connectors for video inputs and outputs. When the HDSD9025TR is operating in the high definition mode
the SDI outputs will not have any video on them.
SDI PROGAM IN
Input BNC connector for 10-bit serial digital component video signals, compatible
with the SMPTE 259M standard. In standard definition mode, the HDSD9025TR is capable of
working with the standard definition video formats shown in Table 2-5.
DDR IN SDI
This input BNC connector (available only on the HDSD9025DDR) is for 10-bit serial digital
video signals, compatible with the SMPTE 259M standard. This input is used to recover VANC
data from the DDR source and should be connected directly to the video output of the Digital
Disk Recorder.
SDI PROGAM OUT Standard definition serial digital video output with RP201 Three line VITC.
SDI CHAR OUT
Standard definition serial digital video output with RP201 Three line VITC and
Characters keyed in.
ANALOG CHAR OUT
video with RP201 Three line VITC and Characters keyed in.
2.1.3. Colour Black Reference Connections
COLOUR BLACK REFERENCE IN Input BNC connector for a 27.97 frames per second reference. This
should be the same reference used to genlock 29.97 frames per second audio sources in
applications where the system video type is 1080p/23.98sF. The input can be either a 1 V p-p
NTSC sync or colour black reference. This input is only required when the input video is
1080p/23.98sF.
2.1.4. Video Recorder Timecode Connectors
These time codes will be at the system video frame rate.
INSTALLATION
In high definition mode, the HDSD9025TR, HDSD9025DDR and
Composite Analog video output that is the same as the SDI CHAR OUT
Revision 1.3
9025TR Series Film Footage Encoders Manual
Page 2-4
Advertisement
Table of Contents
