Connecting The Audio Ltc Reader; Connecting The 9025Tr To Key Log Tracker; Physical Connections; Ey Log Tracker - evertz 9025TR Series Instruction Manual

2.7.2. Connecting the Audio LTC Reader

Connect the LTC output from your audio player to the AUDIO LTC IN XLR connector. When using an
unbalanced input to the reader, the signal should be applied to pin 3 of the reader input connector.
Normally, the unused input, (pin 2) should be connected to ground (pin 1). This input is used to read
timecode from the audio player when it is being controlled externally, so that the audio time code can be
properly logged.
The AUDIO LTC IN connector is also used to read film time code from the 5550 decoder.
2.8. CONNECTING THE 9025TR TO K
The 9025TR is controlled using version 1.5.25 or later of the Evertz Film system's Graphical User interface
(GUI) K L TRACKER™.
EY OG
System requirements for running K
•
CPU: Pentium III
•
Operating System:
recommended: Win 2000, Win XPPro
•
RAM: 256 Mb recommended
•
mouse
•
Video: 2 Mb, 800 x 600 minimum
•
CD-ROM
•
Hard Disk: 20 Mb Free
•
Serial Ports: 2 available
•
local or network printer for printing reports (recommended)
•
sound card with speakers used to generate system sounds when logging (recommended)

2.8.1. Physical Connections

A nine pin sub-miniature 'D' connector (SERIAL CONTROL) is provided for connection to a computer
running the Evertz Film system's Graphical User interface (GUI) K
provides a bi-directional RS-232-C data link at 57,600 baud. The K
to configure the 9025TR's hardware for different applications. Configuration sets can be saved and
recalled to speed setups of the hardware.
KeyKode, ink code and pulldown relationship of the film transfer during the transfer.
In order to connect your 9025TR to your computer make a cable as shown in Figure 2-9. Use this cable to
connect the computer's COM port to the SERIAL CONTROL connector on the rear of the 9025TR. The
9025TR serial port does not have connections for the DTR, DSR, DCD and RI handshake lines. A
standard 9 pin 'straight through' cable may work with some computers if the handshake lines are internally
pulled to the active state.
INSTALLATION
9025TR Series Film Footage Encoders Manual
L TRACKER™
EY OG
L TRACKER™:
EY OG
In addition, K
Revision 1.3
L TRACKER™. This serial port
EY OG
L TRACKER™ software is used
EY OG
L TRACKER™ logs the time codes,
EY OG
Page 2-13