Table of Contents
Advertisement
3.6.3. Selecting and Positioning the Individual Character Inserter Windows
Separately positionable character windows displaying the generator time and user bits are available.
There are also separate windows for the ATC, LTC and auxiliary LTC reader time and user bits. The
SHAFT ENCODER knob in conjunction with the HORZ and VERT keys controls the position of the
character windows. The VCG CONTROL ON/OFF key selects whether the video character generator
(VCG) keyer is on or off. The use of these keys in combination with the VCG CONTROL SELECT key
selects which windows are displayed and their position on the screen.
Press VCG CONTROL SELECT to enable the Window Select mode. All the character windows will
appear on the screen with the window for the generator time highlighted. Use the CHAR GEN ON/OFF
key to turn the Time window on or off. Press the CHAR GEN WINDOW key to highlight the Source ID
window. Use the VCG CONTROL ON/OFF key to turn the highlighted window on or off. Press and
hold the HORZ key and turn the SHAFT ENCODER knob to move the window horizontally. Press and
hold the VERT key and turn the SHAFT ENCODER knob to move the window vertically. Turn the
SHAFT ENCODER knob without any keys held down to select the next window and then turn it on or
off and move it to the desired location in the same way. The HD9010TM-IRIG returns to the normal
VCG display mode after the last window has been selected. Windows that were turned off in Window
Select mode will disappear.
3.6.4. Positioning the Overall Character Display
In the normal VCG display mode, when none of the windows are highlighted, the arrow keys ( ,
) move all the displayed windows by the same relative amount. For example, to move the time and
source ID/status windows both down by one line press the
3.6.5. Special VCG Indicators
The following special indicators are used between the seconds and frames digits of the time window in
the character inserter to identify non drop frame and drop frame code (NTSC only)
Non Drop Frame
Drop Frame (NTSC) Period (.)
3.7.
GENERAL CONFIGURATION ITEMS
The UTILITY SETUP menu is used to set up various items related to the overall operation of the
HD9010TM-IRIG such as Video standard, LTC output levels, genlock phasing, and firmware versions.
Table 3-4 shows the items available in the UTILITY SETUP menu. Sections 3.7.1 to 3.7.6 give detailed
information about each of the sub menus.
OPERATION
HD9010TM-IRIG HDTV Time Code Master / IRIG-B Reader Manual
Colon (:)
Revision 2.1
key.
,
,
Page 3-16
Advertisement
Table of Contents
