Table of Contents
Advertisement
Shortcut Delivery of a Programmed Infusion
Shortcut Delivery of a Programmed Infusion
Note:
Shortcut Delivery in Programmable Mode
5-2
If the desired delivery profile has been programmed
and is currently stored in the pump's memory, you
can shortcut directly to the preprogrammed infusion.
To deliver an infusion, its parameters must have been
programmed and stored in the pump's memory. If the
desired infusion is NOT currently in the pump's mem-
ory, you must program it before delivery is possible.
Refer to the appropriate section(s) in Chapter 3 for
complete information on programming infusion profile
parameters.
To start a previously programmed infusion when the
pump is in Programmable Mode:
Press ON/OFF to turn on the pump. The pump
1.
displays:
YES to Program
RUN to Repeat
Press RUN/HOLD . The infusion rate and volume are
2.
displayed, alternating with the name of the profile
last delivered or programmed.
Press RUN/HOLD again to start infusing the profile
3.
displayed, or press NO until your desired profile is
displayed, then press RUN/HOLD to begin delivery.
6060™ Multi–Therapy Pump Operator's Manual
07-19-12-353
Advertisement
Table of Contents
