Table of Contents
Advertisement
Programming an Infusion
Ready Screens / Final Confirmation Screens
3-16
When you have entered and/or reviewed all infusion
parameters, the pump displays:
This indicates that the programmed parameters have
been saved and will be retained until the profile is
reprogrammed or the pump's memory is cleared.
(See "Clearing the Memory," 5-9).
The screen is also displayed in Lockout Mode, if you
press
RUN
1.
If you want to change a parameter and the pump is
not in Lockout mode, press NO when the
screen is displayed. The pump then displays:
CHECK or CHANGE
followed by the
Press YES to accept, or NO to change the values you
2.
just programmed if desired.
If you press RUN from the
3.
following screens are displayed alternately:
Rate/hr(ml)
125
Press RUN to begin infusing, or NO/REVIEW to
4.
review each programmed parameter (See"Reviewing
Profile Parameters," 3-17.)
6060™ Multi–Therapy Pump Operator's Manual
READY
(PROFILE)
at the RUN to Repeat prompt.
(PROFILE)
DELAY DELIVERY?
AMT
100.0
(PROFILE)
Press Run
READY
screen.
READY
screen, the
07-19-12-353
Advertisement
Table of Contents
