Phone Parameters - Bosch D9412GV4 Program Entry Manual

D9412GV4/D7412GV4/D7212GV4
4.
5.
When the keypad reads Parameter Saved, your selection has been configured.
3.2

Phone Parameters

The program items in this category describe panel wide characteristics for telephone dialing,
receiver format, and supervision.
Phone # Format
Default:
Selection:
ModemIIIa
Contact ID
Central Station Receiver Format for Transmission of Reports: Modem format provides many
reporting advantages over the Contact ID format. Refer to the D6500 Report Directory (P/N:
74-04651-001) for more information about the effect of reporting formats.
Reports identify points as 001 through 247 and passcode User ID codes as 000 through 999 at
the D6500 or D6600 Receiver (unless Point/User Flag is programmed Yes; refer to
Section Point/User Flag, page 19 in this section). When reporting point events, ModemIIIa
Communication Format also sends point text to the D6500 or D6600 as programmed in Point
Assignments.
Keypad Programming of Phone # Format
D1255
1.
2.
3.
When the keypad reads PARAMETER SAVED, your selection has been configured.
D1265
1.
2.
3.
4.
When the keypad reads Parameter Saved, your selection has been configured.
Point/User Flag
Default:
Selection:
Bosch Security Systems, Inc.
The Pause (3-sec pause - "C") and DT Detect (Dial Tone Detect - "D") softkeys enter
special characters. The Backspace softkey allows you to erase characters. The Clear
softkey allows you to clear the entire phone number. The [COMMAND] and [ENTER] keys
allow you to enter an * or a #. Use the softkeys, the number buttons, and the
[COMMAND] and [ENTER] keys on the keypad to enter the new phone number.
Press the Save softkey.
ModemIIIa
ModemIIIa
2
ModemIIIa
ANSI-SIA Contact ID
Refer to Section 2.5.1 Keypad Programming Menu, page 12 to access Keypad Programming
and navigate to the PHONE PARAMETERS option.
At the PHONE 1 - 4 prompt, enter the phone route number you wish to configure and
press [ENT].
Press [NEXT] or [PREV] to toggle between Contact ID and ModemIIIa
select the desired phone format.
Refer to Section 2.5.1 Keypad Programming Menu, page 12 to access Keypad Programming
and navigate to the Phone Parameters option and press the corresponding softkey.
At the Phone (1 - 4) prompt, enter the phone route number you wish to configure and
press [ENTER]. The current configuration shows.
Press the Edit softkey to change the phone format.
Select the softkey for the option you wish to change. Press the Save softkey.
No
Yes or No
Program Entry Guide
2
2
or Contact ID
2
Communication Format
Panel and Area Wide Parameters | en
2
and press [ENT] to
F.01U.218.312 | 04 | 2012.03
19
2