Access Control Functions - Bosch D7212GV3 Program Entry Manual

D7212GV3 | Program Entry Guide | 2.0
Use this function to test Controlled points in areas
within the keypad's scope without sending reports to
the central station. 24-hour points cannot be tested
using this Walk Test Mode.
Fire Test
Default: P
Selection:
-, E, or P
Function Function Name
No.
12 Fire Test
Use this function to test 24-hour points in areas within
the scope of the keypad where the function is
entered. Controlled points, P## Type 1, 2, 3, cannot
be tested using the Fire Walk Test Mode.
Send Report
Default: P
Selection:
-, E, or P
Function Function Name
No.
13 Send Report
Use this function to test the communication link
between the control panel and the central station
receiver(s). It can send a Test Report or a Status
Report to the phone numbers programmed in
Routing. The Test Report includes additional
information if Expand Test Report is enabled in
Section 2.1 Phone on page 8.

2.10.3 Access Control Functions

Door Control
Default: P
Selection:
-, E, or P
This feature is not available with the D7212GV3.
Keep the default setting.
Access Ctl Level
Default: P
Selection:
-, E, or P
This feature is not available with the D7212GV3.
Keep the default setting.
Bosch Security Systems, Inc. | 10/11 | F01U170808-02
Panel and Area Wide Parameters
Change Display
Use this function to select either a bright or dim
Alternate
display with loud or soft keypad warning tones. You
Keystroke
can also choose the time and date display.
[COMMAND][5][8]
Change Time/Date
Use this function to set the time and date in the
control panel.
Alternate
Keystroke
Change Passcode
[COMMAND][4][1]
or
[COMMAND][4][2]
Use this function to change your passcode. This is a
panel-wide function that can be executed from any
keypad assigned to an area where the user has
authority.
Default: E
Selection:
-, E, or P
Function Function Name
No.
15 Change Display
Default: E
Selection:
-, E, or P
Function Function Name
No.
16
Change Time
and Date
Default: P
Selection:
-, E, or P
Function Function Name
No.
17
Change
Passcodes
Refer to Section 2.10.6 Authority Level
Selections on page 61 for a detailed
description of the functions on the
following pages. These parameters
determine only if the authority level
functions are passcode protected.
Regardless of whether an E or a P is
entered when a COMMAND 55 is
performed, the keypad asks for the user's
current passcode first.
EN | 57
Alternate
Keystroke
[COMMAND][4][9]
Alternate
Keystroke
[COMMAND][4][5]
Alternate
Keystroke
[COMMAND][5][5]