Bosch D9412GV4 Program Entry Manual page 48

48 en | Panel and Area Wide Parameters
Figure 3.3 COMMAND 43 Flow Chart (D1265)
RPS Network Address
Default
Selection:
0 to 255
This prompt contains the network host name or the IP address for RPS that the control panel
uses to call RPS.
An IPv4 address has four fields. Each field has a range of 0 to 255. For example, an IP address
is expressed as 110.227.64.190. Contact your network administrator to determine the IP
address to which the RPS computer is connected. If a B420 Ethernet Communication Module
is installed, then the control panel has the option to use a host name (for example,
www.bosch.com), for the RPS Network Address .
Refer to Section RPS Network Address, page 48 and Section RPS Port Number, page 48.
RPS Port Number
Default
Selection:
This prompt specifies the destination port for outgoing RPS session requests to the IP
address specified in RPS Network Address.
Keypad Programming of RPS Network Address and RPS Port Number
D1255
F.01U.218.312 | 04 | 2012.03
Blank
0.0.0.0 to 255.255.255.255 or [host name]
There are four numbers for an IPV4 address. Leading zeros are not
required. A host name can be used if a B420 network communication
module is installed on the control panel.
7750
1 to 65535
Program Entry Guide
D9412GV4/D7412GV4/D7212GV4
Bosch Security Systems, Inc.