Bosch D9412GV4 Program Entry Manual page 181

D9412GV4/D7412GV4/D7212GV4
4.
5.
NOTICE!
The keypad does not accept invalid byte numbers.
6.
7.
D1260
1.
2.
3.
4.
5.
6.
NOTICE!
The keypad does not accept invalid byte numbers.
7.
IPv4 Subnet Mask
Default:
Selection:
This defines the sub-network class. When this is defined through the DHCP service, leave the
default value.
Keypad Programming of IPv4 Subnet Mask
D1255
1.
2.
3.
4.
5.
NOTICE!
The keypad does not accept invalid byte numbers.
Bosch Security Systems, Inc.
Press [ENT] at the IP ADDRESS option. The currently configured IP address shows. An
invisible editing cursor is enabled for the first byte.
The [PREV] button acts as a [Backspace] key. Press [PREV] to delete the characters of
the byte, and then enter the new byte numbers, or press [NEXT] to move to the next
byte.
Repeat Step 5 to enter the correct numbers for each byte.
Press [ENT] to save the changes.
Refer to Section 2.5.1 Keypad Programming Menu, page 12 to access the Tools Menu and
navigate to the Programming option.
Press [ENTER] to enter the Programming option.
Press [ENTER] at the Address Parameters option to enter it.
Press [ENTER] at the IP Address option. The current configured IP address shows.
To change the setting, press the Edit softkey.
The Previous and Next softkeys move the cursor through the bytes. The Backspace
softkey allows you to erase characters. The Clear softkey allows you to clear the entire IP
address. Use the softkeys and the number buttons on the keypad to enter the new IP
address.
Press the Save softkey to save the changes.
255.255.255.0
0.0.0.0 to 255.255.255.255
Refer to Section 2.5.1 Keypad Programming Menu, page 12 to access the TOOLS MENU
and navigate to the PROGRAMMING option.
Press [ENT] to enter the PROGRAMMING option.
Press [ENT] at the ADDRESS PARAM option to enter it.
Press [ENT] at the SUBNET MASK option. The currently configured subnet mask address
shows. An invisible editing cursor is enabled for the first byte.
The [PREV] button acts as a [Backspace] key. Press [PREV] to delete the characters of
the byte, and then enter the new byte numbers, or press [NEXT] to move to the next
byte.
Program Entry Guide
SDI2 Modules | en 181
F.01U.218.312 | 04 | 2012.03