Voltage Regulator; Testing The Voltage Regulator; Voltage Regulator Removal; Voltage Regulator Installation - Club Car Precedent 2014 Maintenance And Service Manual

ELECTRICAL COMPONENTS (GASOLINE
VEHICLE)

VOLTAGE REGULATOR

See General Warnings on page 1-2.

TESTING THE VOLTAGE REGULATOR

See Test Procedure 11 – Voltage Regulator on page 19-22.

VOLTAGE REGULATOR REMOVAL

1. Disconnect battery and spark plug wire(s). See Disconnecting the Battery – Gasoline Vehicles on page 1-3.
2. Disconnect the voltage regulator connector (3) from the wire harness (Figure 20-16, Page 20-13).
3. Remove the voltage regulator mounting screw (2) and remove the voltage regulator (1).
2432

VOLTAGE REGULATOR INSTALLATION

1. Position the voltage regulator (1) and install the mounting screw (2) (Figure 20-16, Page 20-13). Tighten screw to
23 in·lb (2.6 N·m).
2. Connect the voltage regulator three-pin connector (3) to the wire harness.
3. Connect battery and spark plug wire(s). See Connecting the Battery – Gasoline Vehicles on page 1-4.
4. Place Forward/Reverse handle in NEUTRAL and place the neutral lockout cam in the MAINTENANCE position.
Start the engine and check regulator for proper functioning as described in the voltage regulator test procedure.
See Test Procedure 11 – Voltage Regulator on page 19-22.
Figure 20-16 Voltage Regulator
2014 Precedent ® Golf Car Maintenance and Service Manual
Voltage Regulator
3
1
20
Page 20-13