Epson G Series Maintenance Manual page 204

Hide thumbs Also See for G Series:

Table of Contents

G3 Maintenance 12. Lithium Battery

For the EPSON RC+ 7.0 Ver. 7.2.x or later (firmware Ver.7.2.x.x or later), the

recommended replacement time for the battery can be checked in the [Maintenance] dialog

box of the EPSON RC+ 7.0.

For details, refer to the following manual.

RC700 series Maintenance Manual 6. Alarm

The battery may run out if it passes the recommended replacement time.

If no warnings of voltage reduction occur, the calibration for all joints is not necessary.

You need to perform calibration if the position moves from the originals after replaced the

Always use the lithium battery and battery board designated by us.

(Refer to 15. Maintenance Parts List.)

Be careful of the battery polarity to connect it correctly.

Battery unit (Lithium battery)

Battery board

Hexagonal wrench (width across flats: 3 mm)

For cutting wire tie

For M4 screw

For fixing battery unit (battery)

For fixing cable

G series Maintenance Rev.3