Table 1-4 J3 Connector - ICP DAS USA ET-6000 Series User Manual

ГК Атлант Инжиниринг – официальный представитель в РФ и СНГ
Chapter 1 Introduction


Serial/Ethernet Interface
The definition of the two interfaces is same as for a single unit ET-6000 series module.
J1 Connector
Refer to Sec.1.3 Module Selection for more details regarding the pin assignment of the
J1 Connector for all types of two- unit ET-6000 series modules.
J1 LED Indicators
Refer to Sec.1.3 Module Selection for more details regarding the J1 LED Indicators for all
types of two-unit ET-6000 series modules.
J3 Connector (Two Units)
Pin number
52
53
54
The definition of the 3 pins above is applicable to all types of the two units ET-6000 series
modules (Two units).The definition of the other pins is dependent on the different types of
the two units ET-6000 series module.
The definition of 4 LED Indicators at the far right is same as for a single unit ET-6000
series module. All other LED indicators are dependent on the different type of two-unit ET-
6000 series modules.
ET-6000 User's Manual, 2007, Sep., V1.1,
+7(495)109-02-08 sales@bbrc.ru www.bbrc.ru

Table 1-4 J3 Connector

Name
+VS
GND
F.G.
Function
The ET-6000 series can be
powered using a 10-30V DC
supply
Ground connection
Frame Ground
J3 LED Indicators
6PH-002-11----------29