ICP DAS USA ET-6000 Series User Manual page 34

ГК Атлант Инжиниринг – официальный представитель в РФ и СНГ
Chapter 1 Introduction


Note:
Only the display version modules (ET-6000D series) include a 5-digit 7-segment LED. The
ET-6000 series is the non-display version.
2. The format of COM Port Baud Rate is as follows:
5-digit LED Group-ID:22222
LED-1: COM Port number
LED-2~LED-5: Displays the Baud Rate and is determined as (Baud Rate/100)
Therefore, a displayed value of 1.1152 means that the Baud Rate of COM1= 115200
bps.
3. The format of the COM port is Data as follows:
5-digit LED Group-ID:33333
LED-1: COM port number
LED-3: Data bit: 5, 6, 7 or 8
LED-4: Parity bit, 0=No parity, 1=Odd parity, 2=Even parity
LED-5: Stop bit, 1 or 2
The default operation mode of the COM port is 5 (Console mode)
Refer to Appendix C for more details regarding the operation modes of the COM port.
4. The format of the Ethernet socket information is as follows:
5-digit LED Group-ID:44444
LED-1: Indicator, which is 0.
LED-2~LED-3: The number of free sockets available. (Default is 30 for the ET-6000)
LED-4~LED-5: The number of sockets currently being used by clients. (Default is 0)
If a client connects to the ET-6000, the number of free-sockets will be decreased and
the number of used-sockets will be increased. If the number of free-sockets is
reduced to 0, then no extra clients can connect to the ET-6000. The default number of
free-socket for the ET-6000 is 30. Therefore, the server allows up to 30 clients to
connect to a single ET-6000.
The TCP port for the Web server is a well-known port used for TCP/IP communication,
and the default is 80.
Note:
If the 5-digit LED does not display the information as above, the following steps should be
taken:
Switch the Power off
Check that the Init/Normal switch is in the Normal position. (Refer to Sec 1.4.3 Left
Panel Description)
Switch the Power on and double check the displayed data.
ET-6000 User's Manual, 2007, Sep., V1.1,
+7(495)109-02-08 sales@bbrc.ru www.bbrc.ru
6PH-002-11----------32