Connecting The Hardware - ICP DAS USA ET-6000 Series User Manual

ГК Атлант Инжиниринг – официальный представитель в РФ и СНГ
Chapter 1 Introduction


1.5.2

Connecting the Hardware

Host PC
Step 1: Connect the RS-232 download-cable (CA0910F) between the ET-6000 and
COM Port the Host PC, as shown in the diagram above
Step 2: Apply the power (+Vs, GND) to the ET-6000. +Vs can be in a range from +10
to +30V DC.
Notes:
In single unit ET-6000 series modules, V+ is connected to Pin 30 of the J2 connector, and
GND is connected to Pin 31 of the J2 connector.
In a two-unit, V+ is connected to Pin 52 of the J3 connector, and GND is connected to Pin
53 of the J3 connector.
Refer to Sec. 1.4.1 Front Panel Description for more details regarding pin assignments.
ET-6000 User's Manual, 2007, Sep., V1.1,
+7(495)109-02-08 sales@bbrc.ru www.bbrc.ru
RS232
Switch/Hub
Power supply
Ethernet
Pin31
Pin30
+10~30V
6PH-002-11----------39 
GND