ICP DAS USA ET-6000 Series User Manual page 78

ГК Атлант Инжиниринг – официальный представитель в РФ и СНГ
Chapter 3 Web Configuration Page


DHCP Select this option If there is a DHCP
server on the network, the IP address
can be assigned automatically by the
server.
Firmware Firmware Version and Date
Ver.
MiniOS7 MiniOS7 Version and Date
Ver.
DHCP function
DHCP (Dynamic Host Configuration Protocol) is a method used to dynamically assign
temporary numeric IP addresses as required.
When the DHCP function is enabled, the ET-6000 module will automatically load the
IP/Mask/Gateway address saved in the EEPROM if the ET-6000 cannot get a dynamic IP
address from the DHCP server on boot up. This may occur if the DHCP server is unavailable
or if the Ethernet cable/device between the module and the Host PC is damaged.
In this situation, the ET-6000 will not continue to make requests to the DHCP server until the
next reboot, even if the DHCP function is enable.
Notes:
For correct IP/Mask/Gateway address information, please consult the network administrator.
If you don't have a DHCP server available on the network, it is recommended that the DHCP
function is disabled.
No matter whether a static IP or a dynamic IP address is used, the IP address will be displayed
on the 7-segment of SMMI LED (ET-6000D module only). Refer to Sec 1.4.1 "Front Panel
Description" for more details.
ET-6000 User's Manual, 2007, Sep., V1.1,
+7(495)109-02-08 sales@bbrc.ru www.bbrc.ru
0 (Disable)
1(Enable)
Varies depending
N/A
Varies depending
N/A
6PH-002-11----------76 
0 (Disable)
on the Module
on the Module