Table 1-2 Rj45 Led; Table 1-3 J2 Connector - ICP DAS USA ET-6000 Series User Manual

ГК Атлант Инжиниринг – официальный представитель в РФ и СНГ
Chapter 1 Introduction


Name
LINK/ACT
10/100M
J1 Connector
Refer to Sec.1.3 Module Selection for more details regarding the pin assignment of the
J1 Connector for all types of single unit ET-6000 series modules.
J1 LED Indicators
Refer to Sec.1.3 Module Selection for more details regarding the J1 LED Indicators for all
types of single unit ET-6000 series modules.
J2 Connector
Pin number
30
31
32
The definition of the 3 pins above is applicable to all types of the single unit ET-6000
series modules (Single unit). The definition of the other pins is dependent on the different
type of ET-6000 series module.
Note:
Appendix G describes how to connect the Frame Ground to the ET-6000 series module.
ET-6000 User's Manual, 2007, Sep., V1.1,
+7(495)109-02-08 sales@bbrc.ru www.bbrc.ru

Table 1-2 RJ45 LED

LED Action
ON
OFF
Flashing Green
OFF
Orange

Table 1-3 J2 Connector

Name
+VS
GND
F.G.
Function
Ethernet link detected
No Ethernet link detected
Ethernet packet received
Speed 10 Mbps
Speed 100 Mbps
Function
The ET-6000 series can be
powered using a 10-30V DC
supply
Ground connection
Frame Ground
6PH-002-11----------26