ICP DAS USA ET-6000 Series User Manual page 138

ГК Атлант Инжиниринг – официальный представитель в РФ и СНГ
+7(495)109-02-08 sales@bbrc.ru www.bbrc.ru
Chapter 9 Console Mode
Use this command to reset the ET-6000.
3. Default
Use this command to restore the settings to the factory default
Format: default [mode]
mode:
0: All settings. Set all settings to the factory default.
1: Configuration. It includes Ethernet, Serial Port, Basic and Module I/O Settings.
2: Authentication. It includes Account and IP filter settings.
3: Web HMI. Set the Web HMI settings to the factory default.
4: Pair Connection. Set the Pair Connection settings to the factory default
Refer to "Load All Setup Default" inSec. 3.2.3 Basic Settings for more details.
4. Setip/Ip
This function is used to change the IP address of the ET-6000.
Format: setip ip1.ip2.ip3.ip4
ip1.ip2.ip3.ip4: This is a 32-bit address, such as 192.168.255.1
5. setmask/mask
This function is used to change the Mask address of the ET-6000.
Format: mask m1.m2.m3.m4
m1.m2.m3.m4: This is a 32-bit address, such as 255.255.255.0
6. setgateway/gateway
This function is used to change the gateway address of the ET-6000.
Format: gateway ip1.ip2.ip3.ip4
ip1.ip2.ip3.ip4: This is a 32-bit address, such as 192.168.0.1
7. seteid/mac
This function is used to read the Mask address of the ET-6000, and isn't able to be
changed.
Format: Seteid(mac)
Returns the MAC address, such as
MAC=00:0d:e0:a3:dd:af
8. com1
This command is used to configure the Baud Rate and Data format of COM1.
Format:
com1 [baud] [databit] [parity] [stopbit]
baud: 300, 600, 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200 bps
databit: 7, 8
parity: 0 (None), 1 (Even), 2 (Odd)
stopbit: 1, 2
9. commode
This function is used to change the operation mode of COM1.
ET-6000 User's Manual, 2007, Sep., V1.1,
6PH-002-11----------136