Procedure For Using The Opc Server; Opc Server Example Using Modbus Protocol - ICP DAS USA ET-6000 Series User Manual

ГК Атлант Инжиниринг – официальный представитель в РФ и СНГ
+7(495)109-02-08 sales@bbrc.ru www.bbrc.ru
Chapter 7 OPC Server
7.2

Procedure for using the OPC server

Step 1: Read the following documents
Readme.txt: contains the latest important information, including:
•
A list of files contained on the shipped CD
Reversion.txt: contains the revision history information, including
•
Bugs
•
New modules supported
Step 2: Install the OPC server by executing:
CD:\NAPDOS\ET6000\Tools\Napopcsvr\NapOPCServer.exe
Note: If there is an older version of the Nap OPC Server installed on the PC, and
must be uninstalled before installing the new version.
Step 3: Read the manuals describing how to begin.
The NapOPCSvr.pdf
7.3

OPC Server Example using MODBUS protocol

The following is an example of accessing Digital input and output values from an ET-6000
Step 1: Connect the ET-6000 controller (refer to Sec. 1.4.2) and configure its network
settings (IP, Mask and Gateway - refer to Sec. 2.1)
Step 2: Run the OPC server
Step 3: Add/Create a new device and to search for I/O modules using Modbus /TCP
protocol
\
3.1
ET-6000 User's Manual, 2007, Sep., V1.1,
is the user's manual describing how to use the OPC server
6PH-002-11----------126