7: Communicator; Communicator Installed; Pots Settings - Honeywell Fire-Lite Alarms ES-1000X Manual

Master Programming Level
3.5.7 Communicator
PROGRAMMING
1=HISTORY
2=COMMUNICATOR
3=ANNUNCIATORS
Programming Screen #3

Communicator Installed

The pre-installed communicator provides communication to a central station. The ES-1000XI model does not come with a pre-installed com-
municator. Use of the communicator requires it be enabled in user programming. Pressing 1 while viewing the Communicator Screen #1 will
change the display to Installed Yes. Each press of the 1 key will cause the display to toggle between Installed Yes and Installed No.

POTS Settings

COMMUNICATOR
1=INSTALLED
2=POTS SETTINGS
3=IP SETTINGS
Communicator Screen #1

POTS Line (X)
If telephone lines are connected to the IPOTS-COM board at J4 (Line 1) and J5 (Line 2), their settings can be configured by pressing 1 or 2,
respectively. Pressing 1 or 2 will display the following screen. The programming options for Line 1 and Line 2 are identical.
Phone Line (X) Enable
To enable the phone line, press 1 while viewing the POTS Line (X) Screen #1 to change the display to Enabled Yes. Each press of the 1 key
will cause the display to toggle between Enabled Yes and Enabled No.
Type
POTS LINE X
1=ENABLED
2=TYPE
3=SUPERVISED
POTS Line X Screen
Press 1 to select Touchtone dialing, 2 to select Rotary dialing with a make/break ratio of 67/33 or 3 to select Rotary dialing with a
make/break ratio of 60/40.
Supervised Phone Line
POTS LINE X
1=ENABLED
2=TYPE
3=SUPERVISED
POTS Line X Screen
Refer to the table on page 43 for permissible settings.
ES-1000X Series Manual — P/N LS10133-000FL-E:A 6/21/2023
The communicator settings allow the user to configure the settings for the optional IPOTS-COM and CELL-
MOD/CELL-CAB-FL if installed in the system. Pressing 2 while viewing the Programming Screen #3 will
cause the following Communicator options to be displayed:
COMMUNICATOR
1=INSTALLED
2=POTS SETTINGS
3=IP SETTINGS
Communicator Screen #1
The POTS settings configure the system when telephone lines are used to contact central station. Pressing 2
while viewing the Communicator Screen #1 will display the following.
YES
To select the type, press 2 while viewing the POTS Line (X) Screen #1. The following screen will be displayed:
YES
YES
The Supervised Phone Line feature allows the user to disable the supervision of Phone Lines when using an
alternate means of secondary transmission path. The factory default setting is Phone Line (X) supervised.
YES
Supervision must be set to Yes if the selected transmission path is POTS.
YES
Pressing 1 for Supervision while viewing the POTS Line (X) Screen #2 will change the screen to read Supervi-
sion No. Each press of the 1 key while viewing this screen will toggle the option between Supervise Yes and No.
COMMUNICATOR
NO
1=PRI COMM PATH
2=SEC COMM PATH
3=TBL REPORT LIMIT 0
Communicator Screen #2
POTS SETTINGS
1=LINE 1
2=LINE 2
3=GAINS
POTS Settings Screen
POTS LINE X
1=ENABLED NO
2=TYPE TOUCHTONE
3=SUPERVISED NO
POTS Line X Screen
TYPE
1=TOUCHTONE
2=ROTARY 67/33
3=ROTARY 60/40
Type Settings Screen
Programming
COMMUNICATOR
1=REPORT SYTLE POINT
2=EVENT CODES
Communicator Screen #3
79