Section 6: Fs-Tools Upload/Download; Fs-Tools Up/Download - Honeywell Fire-Lite Alarms ES-1000X Manual

Addressable fire alarm control panel

page of 170

/ 170
Contents
Table of Contents
Bookmarks

Table of Contents

Important! The FACP will automatically reset 2 minutes after completion of a user program download via the FS-Tools programming util-

ity. To prevent program corruption, the operator must wait until this panel reset occurs before performing any panel operations.

The control panel may be programmed or interrogated off-site via the public switched telephone network or locally using a USB cable. Any

personal computer with Windows

Tools, may serve as a Service Terminal. This allows download of the entire program or upload of the entire program, history file, walktest

data, current status, system voltages, time and date.

The control panel may also communicate to a local PC at the job-site. The PC must be connected to the USB connector J20 on the FACP

main circuit board. A standard USB cable with male-A to male-A connectors, which must be purchased separately, is required.

Important: Remote modification of FACP programming requires that the panel be enabled for remote download (refer to "FS-Tools

Upload/Download" on page 119). Remote interrogation of panel programming, history logs, detector status, etc., is possible without

enabling the remote download option.

CAUTION: After successfully downloading a program, make certain to perform the following steps:

Print out all programmed data via Print Mode or manually view programmed entries and compare to intended program data

Test all affected panel operations

Immediately correct any problems found

6.1 FS-Tools Up/Download

NFPA 72 requirements state that a technician be on-site and at the control panel whenever the FS-Tools Programming Utility is used to

download any information to the FACP. This applies to local and remote programming.The Remote Download option can be selected from

the main menu screen as shown below after successful login:

Select 2 to login to the panel.

Select 2 to login as a User.

Select the appropriate User login ID:

Enter the User's Master level password. Only a user with master level programming rights can access FS-Tools Up/Downloads. The follow-

ing screen will appear:

Select 2 for FS-Tools Up/Download.

Pressing 1 for Accept Upload will cause the following screen to be displayed:

ES-1000X Series Manual — P/N LS10133-000FL-E:A 6/21/2023