Ipots-Com Communicator; Wiring; Dip Switches - Honeywell Fire-Lite Alarms ES-200X Manual

Installation

2.7 IPOTS-COM Communicator

Two independent telephone lines can be connected to the control panel via the IPOTS-COM Phone/IP Communication Module. Tele-
phone line control/command is made possible via double line seizure as well as usage of an RJ31X style interconnection. Note that it is
critical that the IPOTS-COM Digital Communicator be located as the first device on the incoming telephone circuit to properly function.
Important! The IPOTS-COM must not be used to dial a phone number that is call-forwarded.
Network
Service
Provider's
Facilities
Telephone
Line
Network
Demarcation
Point

Wiring

Connection and wiring of two phone lines is required as shown below.

Dip Switches

There are two configurable dip switches on the IPOTS-COM communicator.
• SW2: 6-position dip switch- FUTURE USE- No configuration necessary.
• SW3: 2-position dip switch- Factory Settings- Do not change unless instructed to do
so by Honeywell.
30
RJ31X
Jack
FACP with IPOTS-COM
mounted internally
Telephone
Answering
System
Figure 2.11 Communicator Installation
IPOTS-COM
J3
J4 J5
LINE1 LINE2 ETH
Module Female
Connectors
Male Plug
Connectors
Figure 2.12 Wiring Phone Jacks
Customer Premises Equipment and Wiring
Unused
RJ-11 Jack
Fax Machine
(Secondary Lines)
Incoming Telco Phone
Tip Green Wire
Ring
To premise phones
Red Wire
Ring
Tip
1 2 3 4 5 6 8
7
RJ31X
Jack
Note: Shorting
bars inside RJ31X
Jack removed
during installation.
Secondary
7 foot Cable
Phone Line
MCBL-7
(ordered
separately)
ES-200X Series Manual — P/N LS10131-000FL-E:C 7/25/2018
IPOTS-COM Communicator
Computer
Telephone
Unused
RJ-11 Jack
Telephone
Ti Green
(Primary Lines)
Incoming Telco Phone
Red Wire
Rin
Ring
To premise
Tip
1 2 3 4 5 6 7 8
RJ31X
Jack
Primary Phone Line
Figure 2.13
IPOTS-COM Dip
Switches
SW2
SW3