Allied Motion Spectrum Controls 2706-P22-SC User Manual page 81

The following transmission is used to remove the time that was just loaded into
the message queue.
Transmission is as follows:
Transmission for Clearing the Message Queue
Beg of
ADDR FUNC
Frame
: FF 06
Response: NONE
Set Day and Date in Broadcast Mode
This command is used to set the date in all displays. This is primarily done using
the automation software to synchronize the date in the displays with the
computer. This requires three separate transmissions. First, set the date. Second,
set the day of week. Third, clear the queue. The following is an example of
setting the day and date to Thursday, January 4, 2001.
Transmission for Setting Date
Beg of
ADDR FUNC
Frame
: FF
NOTE
Transmission for Setting Day of Week
Beg of
ADDR
Frame
: FF
H.O L.O
ADDR ADDR
00 65
1. Set the date.
Transmission is as follows:
H.O L.O
ADDR ADDR
01 00
See InView Display Communication Protocol Functions and Descriptions
on for further explanation of the InView sign protocol being used.
Response: NONE
300 ms pause.
2. Set the day of the week.
The following transmission is used to remove the time that was just
loaded into the message queue.
Transmission is as follows:
H.O
FUNC
ADDR ADDR
01 00
Chapter 4: InView Protocol
DATA
FFFF
DATA
64 ^AZ00^BE;01040^D
L.O
DATA
64 ^AZ00^BE&5^D
LRC
EOF
Error
98 CR
EOF
CR
EOF
CR
User's Manual 0300277-03 Rev. A
4-19
Ready to
rec.
response
LF
Ready to
rec.
response
LF
Ready to
rec.
response
LF