Emi Compliance For 2706-P42-Sc And 2706-P44-Sc Signs; Section 1.7 Mount The 2706-P42-Sc And 2706-P44-Sc Displays - Allied Motion Spectrum Controls 2706-P22-SC User Manual

Section 1.6 EMI Compliance for 2706-P42-SC and 2706-P44-SC Signs

Section 1.7 Mount the 2706-P42-SC and 2706-P44-SC Displays

NOTE
WARNING
WARNING
Chapter 1: Installing InView Message Display
8. Replace the power supply cover using the 6 screws removed when the
cover was removed.
9. Torque the screws to 2.7 Nm (24-lb in.).
10. Connect the power cable to a power source.
This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with installation guidelines, may cause
harmful interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference, in which case the user will
be required to correct the interference at his own expense.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
North American Certifications:
• UL 60950-1
CSA C22.2 No. 60950-1
•
• FCC Part 15 Class A compliance
CE compliance to:
• Low Voltage directive: 2014/35/EU
EN 60950-1
•
EMC directive: 2014/30/EU
•
• EN55032 Class A
Only qualified personnel should install InView displays. InView displays
are for indoor use only and should not be exposed to direct sunlight.
Mounting hardware that is used to hang or suspend signs must be capable
of supporting at least four times the total weight of any/all signs mounted
together.
To preserve integrity of the case, do not drill holes in, or modify, the case.
Hazardous voltage.
Contact with high voltage may cause death or serious injury.
Always disconnect power to sign prior to servicing.
Tension dangereuse.
Tout contact avec une tension élevée peut entraîner la mort ou des
blessures graves.
Déconnectez toujours l'alimentation de l'afficheur avant toute opération
de maintenance
User's Manual 0300277-03 Rev. A
1-7