Emi Compliance For The 2706-P42C2-Sc And 2706-P44C2-Sc Displays; Certifications; Wiring The 2706-P42C2-Sc And 2706-P44C2-Sc Displays - Allied Motion Spectrum Controls 2706-P22-SC User Manual

EMI Compliance for the 2706-P42C2-SC and 2706-P44C2-SC Displays

Certifications

Wiring the 2706-P42C2-SC and 2706-P44C2-SC Displays

WARNING
Appendix B: Installing InView Marquee 2706-P4xC2-SC Message Displays B-5
This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with installation guidelines, may cause
harmful interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference, in which case the user will
be required to correct the interference at his own expense.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Certifications are:
North American Certifications:
UL 60950-1
•
CSA C22.2 No. 60950-1
•
FCC Part 15 Class A compliance
•
CE compliance to:
• Low Voltage directive: 2014/35/EU
EN 60950-1
•
EMC directive: 2014/30/EU
•
EN55032 Class A
•
Hazardous voltage.
Contact with high voltage may cause death or serious injury.
Always disconnect power to the InView display prior to servicing.
Maintain separation of circuits.
Route the incoming power directly to the power connections terminal
block.
Do not run the power wiring over the logic board.
User's Manual 0300277-03 Rev. A