KidKraft Cedar Summit F25745E Installation And Operating Instructions Manual page 81

Step 41: Install Side Supports
A: Place a (411) Side Support on the inside of the Narrow Wall Frame so that it sits behind the (401) TNR Brace
Support at shown in fig. 41.1. Pre-drill holes using a 3/16" (4.8 mm) drill bit, then attach Side Support from the
outside of the Narrow Frame using 3 (WL5) ¼ x 2-1/2" Wafer Lags in the upper holes and 1 (H5) ¼ x 4-1/2" Hex
Bolt (with t-nut) in the bottom hole. (fig.41.1 and 41.2)
B: Repeat step A to install a Side Support on the inside of the Rock Wall Frame. (fig.41.2)
C: Install 1 (H3) ¼ x 2-1/2" Hex Bolt (with lock washer, flat washer and t-nut) into each remaining bolt hole on the
(401) TNR Brace Support. (fig.41.1 and 41.2)
Narrow Wall Frame
1/4"
T-Nut
H5
1/4" Lock
Washer
1/4" Flat
Washer
Wood Parts
2 x Side Support 1-1/4 x 3-1/4 x 46-1/4"
411
Fig. 41.1
1/4" Lock
Washer
1/4" Flat
Washer
411
401
WL5
H5
H3
Hardware
6 x 1/4 x 2-1/2" Wafer Lag
WL5
2 x 1/4 x 2-1/2" Hex Bolt
H3
(1/4" lock washer, 1/4" flat washer, 1/4" t-nut)
2 x 1/4 x 4-1/2" Hex Bolt
H5
(1/4" lock washer, 1/4" flat washer, 1/4" t-nut)
81
Fig. 41.2
401
WL5
H5
H3