Advertisement
Step 9: Join Swing and Slide Assemblies
Part 1
A: With at least two helpers lift the Slide Wall Assembly and Swing Wall Assembly so the (072) Narrow Panel
Back and (073) Narrow Front Panel meet with (083) Wall Panel Back and (082) Panel Front Wall and are tight
together as shown in fig. 9.1.
B: Make sure the assembly is square then on the inside of the assembly, tight to (071) Nest End Panel and
flush to the bottom of the panels attach 1 (091) Floor Joist to (072) Narrow Panel Back and (083) Wall Panel
Back using 4 (S7) #12 x 2" Pan Screws. Attach a second (091) Floor Joist to (073) Narrow Front Panel and (082)
Panel Front Wall with 4 (S7) #12 x 2" Pan Screws. (fig. 9.1 and 9.2)
Fig. 9.1
Fig. 9.2
071
Tight
(both sides)
Wood Parts
2 x
Floor Joist 1-1/4 x 3 x 40-3/4"
091
073
Slide Wall
Assembly
072
071
073
Flush
091
S7
x 4 per board
Hardware
8 x
#12 x 2" Pan Screw
S7
31
Swing Wall
Assembly
081
083
082
083
091
Advertisement
