Advertisement
Step 70: Attach Flange Assembly to Fort
Part 1
A: With a helper place the Flange Assembly flush to the top opening in the Slide Wall as shown in fig.70.1, then
pre-drill 1/8" pilot holes in (431) Upper SL Insert for the 4 upper mounting locations (approximate spots where
circles are on figure), making sure the pre-drilled holes are a minimum of 1" deep. (fig. 70.2)
B: Attach Flange Assembly to (431) Upper SL Insert using 4 (S7) #12 x 2" Pan Screws (with #12 Screw Bezel) in
the pre-drilled holes. (fig. 70.2) Make sure the flat surfaces of the Flange Assembly are flush to (422) TNR Front
Support and both sides of (411) Side Supports as shown in (fig. 70.2)
C: Attach the Flange Assembly flush to bottom of (422) TNR Front Support using 4 (S6) #12 x 1" Pan Screws
(with #12 Screw Bezel) and to both sides of (411) Side Supports using 5 (S6) #12 x 1" Pan Screws per side. (fig.
70.2 & 70.3 & 70.4)
Fig. 70.2
Inside
View
S6
x 5
Fig. 70.3
the 4 holes need
to be pre-drilled
w/ #12
S7
Screw Bezel
w/ #12
S7
Screw Bezel
411
422
10 x
8 x
Fig. 70.1
Outside
View
411
S6
x 5
Hardware
#12 x 1" Pan Screw
S6
#12 x 2" Pan Screw
S7
(with #12 Screw Bezel)
123
Top flush to
Fig. 70.4
Upper SL
Insert
Bottom flush to TNR
Front Support
431
411
Flange
Assembly
422
Advertisement
