KidKraft Cedar Summit F25745E Installation And Operating Instructions Manual page 126

Step 72: Attach TNR 3 Slide Exit to Elbow Assembly
A: Insert flange of Exit Elbow Assembly (slide elbow) into the slots on TNR3 Short Exit. (fig. 72.1)
B: Rotate Slide Exit and use Quadrex Driver as a guide pin so the holes are aligned and attach with 5 (PB1) 1/4 x
3/4" Pan Bolts (with lock nuts) starting with the bottom middle hole and working up each side. (fig. 72.2 & 72.3)
C: At this point make sure all the slide bolts are tight. Use a 7/16" open end wrench to hold nut and then
tighten bolt with Quadrex Driver.
Fig. 72.1
TNR3
Short Exit
Exit Elbow
Assembly
Slot of TNR3
Short Exit
Lock
Nut
Fig. 72.3
PB1
5 x
PB1
Start with
this bolt
Hardware
1/4 x 3/4" Pan Bolt
PB1
(1/4" lock nut)
126
Fig. 72.2
Lock
Nut
Bottom of Slide Views
Other Parts
1 x TNR3 Short Exit
PB1