Advertisement
Step 75: Attach TNR4 Slide to Fort
A: On the fourth attached Elbow Assembly remove the pan bolt and nut which is facing the fort (installed in Step 70).
(fig. 75.1) The bolt will no longer be needed, but keep the lock nut.
B: Loosely attach TNR Long Tube Support (at the slightly bent end) to the slide seam using 1 (PB6) 1/4 x 1" Pan Bolt
(with flat washer and the previously removed lock nut). (fig. 75.2)
C: Rotate TNR3 Tube Support and attach to (071) Nest End Panel using 1 (S6) #12 x 1" Pan Screw as shown in fig.
75.2.
D: Fully tighten screw and bolt.
Fig. 75.2
071
Note: Flat
end down
TNR Long
Tube Support
PB6
S6
Remove PB1 (1/4 x 3/4"
Pan Bolt) first then install
PB6 (1/4 x 1" Pan Bolt
with flat washer)
1 x
#12 x 1" Pan Screw
S6
1 x
1/4 x 1" Pan Bolt
PB6
(1/4" flat washer & 1/4" lock nut - previously removed)
Fig. 75.1
Lock
Nut
Flat
Washer
Hardware
129
TNR Brace
Assembly
Other Parts
1 x TNR Long Tube Support
Advertisement
