Advertisement
Step 2: Access Ladder/Rope Wall Assembly
Part 2
D: Making sure that the pre-sunk holes are facing the outside, place (024) Rope Rail on the ground next to
(022) Right Access so it matches the orientation of the two access rails as shown in fig. 2.5. Attach (025) RW-AL
Support flush to the top of Access Ladder assembly and (024) Rope Rail using 3 (S20) #8 x 1-3/8" Wood Screws
in the top holes and 3 (S11) #8 x 2" Wood Screws in the bottom holes. Pilot holes in (025) RW-AL Support should
be centred over the rails. (fig. 2.3 and 2.4)
E: Place one end of the (026) Access Rope Ladder Gap on the (021) Left Access and the other end on the (024)
Rope Rail so there is a 1-3/8" gap between (026) Access Rope Ladder Gap and the top (023) Tread. Attach using
6 (S11) #8 x 2" Wood Screws. (fig. 2.3)
F: Place (027) Rope Bottom between (024) Rope Rail and (022) Right Access and attach using 4 (S4) #8 x 3"
Wood Screws. (fig. 2.5)
Fig. 2.4
S11
S20
x 3 in top
holes
Flush
Fig. 2.3
025
Fig. 2.5
Wood Parts
1 x
Rope Rail 2 x 2-1/2 x 57-13/16"
024
1 x
RW-AL Support 5/8 x 3-1/4 x 41-3/4"
025
1 x
Access Rope Ladder Gap 5/8 x 3-1/4 x 41-3/4"
026
1 x
Rope Bottom 1-1/4 x 2-1/2 x 18-3/4"
027
x 3 in
S11
bottom
holes
026
025
023
S20
9 x
3 x
4 x
x 6
026
S11
Hardware
#8 x 2" Wood Screw
S11
#8 x 1-3/8" Wood Screw
S20
#8 x 3" Wood Screw
S4
23
021
S4
022
024
022
027
S4
Advertisement
